THE UNIT IS NOT WATER TIGHT AND THEREFORE MUST REMAIN IN THE UPRIGHT POSITION.
Allow to cool for 3 minutes
before removing the steriliser from
the microwave.
Before removing the lid
press the steam vent to
allow steam to escape
away from you. Use
pouring spout to remove
any excess water.
Wash your hands thoroughly before
handling sterilised items. Take care as the
items will be hot.
Remove the basket (rotate basket lid
anti-clockwise to remove) and lift out
sterilised items. Make up feed according to
manufacturer's instructions.
If the steriliser is left unopened bottle will
remain sterile for 3 hours. After this time
re-sterilisation is required.
Always add 80ml of water before use. Ensure the unit
does not boil dry.
Ensure microwave is set correctly on full power.
Always allow 3 minutes cooling time before removing
from the microwave.
When removing the steriliser from the microwave,
take care, as unit will contain hot water and steam.
Place on a hard, heat resistant surface.
Always release steam using the steam vent before
completely removing the lid.
Do not use chemical sterilising solutions / tablets
in the microwave.
If you have a combination oven, ensure grill is
switched off and the oven has cooled before use.
Always follow loading instructions to ensure
sterilisation.
Do not place metallic items in the microwave as
damage could result.
Make sure the microwave turntable is clean and dry
before use.
If components are washed in a dishwasher with
other items, which have residues of strong coloured
sauces (e.g. tomato), they may discolour over time.
Keep out of reach of small children.
COLD WATER STERILISATION
Prepare sterilising solution as instructed by
the sterilising solution manufacturer.
You will need approximately 1.5 L.
Place closer to nature bottle upright inside
the basket and place the basket inside the
steriliser.
Ensure the bottle is filled first, then
continue to fill the Steriliser until the
solution reaches the base of the neck.
Place hood upside down inside the bottle
neck ensuring that it is completely
Place assembled screw cap and teat upside
down inside the hood ensuring that it is
completely submerged.
Assemble the basket lid to the basket with
the twist lock feature ensuring that all the
bottle components are fully submerged in
the Sterilising solution.
Assemble the Steriliser lid to the Steriliser
ensuring the pouring/steam vent is in the
closed position.
3 in 1 uv sterilizer, dryer and storage (8 pages)
Advanced electric sterilizer and dryer (8 pages)
Microwave steam sterilizer (2 pages)